Table Saw
TABLESAWSTablesaw outfeed with PVC rollersIn a one-man shop, ripping sheet goods and long lumber is difficult. I decided to solve this problem by building a roller extension on the back of my tablesaw. When I dis- covered that the commercially available rollers were a bit pricey, I went shopping. For a few bucks I bought a 10-ft. length of 11⁄2-in.-dia. PVC plumbing pipe, a short length of nylon bar stock, several lengths of 1⁄2-in.-dia. steel bar stock, and some angle iron.I made up four rollers by cutting lengths of the PVC and fitting each end of the pipe with bearings made from the nylon bar stock. I made axles from the 1⁄2-in.-dia. steel bar stock and drilled and tapped holes...
